The Original Post

Our project will consist of a bar that when a button is pressed will begin to move towards the left. At this same time there is an LED next to the button which lights up. Once the bar moves and hits the button it stops and the light turns off. Then there is a light off to the side of the project that lights up. Next to this light there is another push button. When this light turns on a servo begins to turn towards the button and when pressed the light above it turns off, and another light on the opposite side of the bar turns on. At this time the bar moves towards the LED,next to this LED is another push button. Then once the bar comes in contact with the push button the LED turns off and the bar stops moving. Then, silmutaneously, there is another LED on the opposite side of the push button that turns on and the servo begins to turn towards it where there is another push button. Once the servo comes in contact with the button the light turns off and the entire process repeats.

This project is brought to you by Christopher Houston, Eddie Dougherty, and Peter Marashio. The parts will be made out of plastic and designed using Solidworks. The electronic portion will be run using an Arduino board and Arduino programming.